If i under cal the VCA the oscillators sound better but they leak a lot when the key board is idle. Im not sure what was up with that before but that gremlin moved out. I can get one range ( up or down ) to work but not both together while the oscillators are scaled properly. If i get the oscillators tuned nice with each other the pitch bend scales incorrectly between the two voices and sounds bad. The mirage key bed has little loops that hold them in so theres no need to solder them. It was hard to get the springs soldered into the right position with the right amount of tension on them. I replaced any springs that were distorted or broken with a set from an old deceased mirage key bed. I cleaned the springs and rails on the key bed with vinegar and it made a great improvement on the keys that were not striking well or without useful velocity info. I dont have a scope here so i am unable to check the digital side but the analog side it starting to make a lot of sense after a few poke and prod sessions with the tweaker. Service Crumar Roadrunner Manual But It.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |